- audio taper
- An A pot. It turns up evenly to the ear. Most volume and tone pots are this kind.
- coil
- One winding of wire in a pickup. A single coil has one, a humbucker has two.
- coil split
- Switching off one coil of a humbucker, so it sounds more like a single coil.
- common
- The switch lug that the selected position connects to.
- ground
- The return path back to the jack sleeve. Every metal part joins it, which keeps hum down.
- hot
- The lead or wire that carries the signal toward the jack tip.
- jumper
- A short wire between two lugs on the same part.
- linear taper
- A B pot. It turns up evenly on a meter, so most of the change is near the bottom.
- link
- Where a humbucker's two coils join. It's soldered, covered and touches nothing else.
- lug
- A metal tab on a pot, switch or jack where a wire is soldered.
- no-load
- A tone pot that leaves the circuit at 10, for the brightest sound.
- parallel
- Two coils side by side. Brighter and a little quieter.
- phase
- Which way a pickup's signal swings. Two pickups out of phase partly cancel and sound thin.
- pot back
- The metal case of a pot. Ground wires are soldered to it.
- push-pull
- A pot with a small switch on it. Pull the knob up to flip the switch.
- RWRP
- Reverse wound, reverse polarity. A middle pickup built that way cancels hum with the neck or bridge in positions 2 and 4.
- series
- Two coils one after the other. Louder and thicker.
- shield
- The bare braid or wire around a pickup's leads. It always goes to ground.
- sleeve
- The jack lug that is ground. It touches the long barrel of the cable plug.
- tin
- Melt a little solder onto a lug or wire end first, so the joint takes quickly.
- tip
- The jack lug that carries the signal. It touches the tip of the cable plug.
- treble bleed
- A small cap (often with a resistor) on the volume pot that keeps the sound bright as you turn down.