Wiring Bench

Grounding without the hum

Where the ground wires go, and why the bridge needs one.

Every metal part that can pick up noise has to be tied back to the jack's sleeve: the pot backs, the switch's ground lug, each pickup's ground lead, the bridge or trem claw, and any shielding.

The bridge ground is the one people forget. It connects the strings to ground. When you touch the strings, your body joins the guitar's ground and the hum drops. Without it, touching the strings changes little or makes things worse.

Daisy chain or star

Most factory guitars run a bare wire from pot back to pot back to the jack. That works fine. A star ground brings every ground to one point instead, which some techs prefer on busy wirings. Either way, what matters is that every metal part reaches the sleeve, and that no part is grounded two different ways that make a loop.

Shielding

Copper foil or conductive paint in the cavities blocks a lot of buzz from lights and screens. It only works if it's tied to ground, usually by a wire to a pot back or by the pot nuts pressing on the foil.

A meter on ohms from each metal part to the jack sleeve should read under 1 ohm. Anything that reads open is floating.