Wiring Bench

Pots and caps: choosing values

250k or 500k, audio or linear, and what the numbers on a cap mean.

The pot value sets how much treble survives on its way to the jack. A higher value loads the pickup less, so more treble gets through.

  • 250k pots are the usual choice for single coils. They take a little edge off pickups that can be bright.
  • 500k pots are the usual choice for humbuckers, which are darker and need the extra treble.
  • 1 meg pots are used for very dark pickups, or when you want everything open.

Audio or linear

Audio taper pots (marked A) change slowly at first and quickly near the top, which matches how we hear loudness. Use them for volume, and usually for tone too. A linear pot (marked B) on volume makes most of the sweep feel like nothing happens, then it drops off a cliff near 0.

Tone caps

The cap decides where the tone knob cuts. A larger cap cuts lower, so the sound gets darker as you turn down. 22 nF (0.022 µF, marked 223) is the common choice for humbuckers and many single coil guitars. 47 nF (0.047 µF, marked 473) cuts lower and sounds darker. Both are common, and which you like is taste.

Treble bleed

Turning the volume down loses treble. A small cap across the volume's input and output lugs, often with a resistor, keeps the top end as you roll back. The builder can add one to any wiring.

Next: Coil splitting, series and parallel