Wiring Bench

Coil splitting, series and parallel

What actually changes inside a humbucker when you pull a knob.

A humbucker is two coils wound in opposite directions with opposite magnets, joined one after the other (in series). The noise each coil picks up is flipped against the other, so it cancels, and the signals add up. That's why a humbucker is loud, thick and quiet.

A 4-wire humbucker brings out both ends of both coils. Two of those leads are joined together and taped: that's the series link. What you do with that link is what splitting and parallel are about.

Split

Ground the series link and one coil is shorted out. You hear a single coil: brighter, thinner, quieter. It also hums again, because the cancelling coil is gone.

Parallel

Wire the two coils side by side instead of one after the other. Both coils still play, so it stays hum cancelling, but it's brighter and quieter than series, somewhere between a full humbucker and a split.

A Les Paul style with a push-pull on each tone knob to split each humbucker.
A Les Paul style with a push-pull on each tone knob to split each humbucker.

Lead colors differ by maker. Check the Tools page, or find the coil pairs with a meter before you solder.

Next: Grounding without the hum